Temperature & Time Setting (Programming) - Pentair Pool Products MiniMax 250 Operating & Installation Manual

Temperature & Time Setting (Programming)
TO CHANGE THE FACTORY TEMPERATURE SETTINGS:
1. Before changing the temperature, make sure the "Temperature" is in the right window, see pages 24
and 25, if "Time" is displayed, press the MODE key to change to the "Temperature Mode".
2. To change the Pool Temperature setting, press the POOL key.
3. To Raise or Lower the Pool Temperature setting, press the proper TEMP key
until the desired setting is displayed.
NOTE: During Programming of the Pool Temperature, the two buttons on the
right are used to
NOTE: Pool Temperature is now set.
4. You can leave the right window displaying the set "Temperature" or by pressing
the MODE key, you can return to the "Time" Mode.
NOTE: To re-set the Spa Temperature, follow the above steps 1. through 4.
while in the "Spa Heating" Mode.
TIME SETTING
1. Make sure heater is turned "OFF" and not in the POOL or SPA "ON" Mode.
2. Place the Controller in Programming Mode by depressing the SET and MODE buttons at the same time.
NOTE: During Programming of the Time Setting, the two buttons on the right
(
Increase
are used to
Raise
P/N 471593
MODE
or
( )
(
Increase
Decrease
Raise Lower
MODE
(
)
Decrease
or
Lower
SET
PROGRAM
POOL OFF SPA
the display setting numbers.
)
POOL OFF SPA
SET
PROGRAM
)
the display setting numbers.
24
TEMP
STEP
TEMP
TEMP
STEP
TEMP
TEMP
STEP
TEMP
Rev. C 11-1-01