Slot Control - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 90-05 : Slot Control to reset or delete (uninstall) blades (slots 1~24).
Delete allows you to completely uninstall the blade. You should do this if you want to remove a blade and
plug it into a different slot and still retain the port assignments. If a different type of interface blade is
being installed in a slot previously used (e.g., changing from a LCA to a DLCA blade), the slot should be
deleted (option 1) first before installing the new interface blade.
Reset allows you to send a reset code.
This program is available only via telephone programming and not through PC
Programming.
NOTE
Input Data
NetLink System ID
Input Data
Menu Number
Item
Item
No.
01

Slot Control

Conditions
When you delete or reset a blade, you must first remove it from its slot then run Program 90-05. When

reusing the slot for another blade, you must plug the blade in or reset the system before the system
can use the slot again.
When you delete or reset a blade, all related programming in Program 10-03-01 is set back to default.

2-818
Program 90 : Maintenance Program
1 = Delete
2 = Reset
3 = Set Busy Out
4 = Reset Busy Out
Input Data
Slot Number (1~24)
90-05 : Slot Control
0 ~ 50 (default = 0)
Program 90 : Maintenance Program
Issue 4.0