Sony NWZ-S515 Service Manual page 72

NWZ-S515/S516/S615F/S616F/S618F
NOTE THE LCD SUB ASSY (LCD801) REPLACING
The LCD sub assy (LCD801) used with this main unit has two
kinds of types of made by EPSON and made by TMD.
When the LCD sub assy (LCD801) is replaced, it is necessary to
write information on LCD used in the main board.
When the LCD sub assy (LCD801) is replaced, when it is sure to
fulfi ll the conditions referring to "1. Discrimination" and "2. Con-
dition to use the LCD Confi g Setting Tool", information on LCD
used for the main board is written according to "3. Prior prepara-
tion", "4. Updating the fi rmware of the main unit" and "5. Use of
the LCD Confi g Setting Tool".
• Part No. of the LCD sub assy (LCD801)
made by EPSON made by TMD
X-2187-040-1 X-2189-452-1
• About the service supply parts of the LCD sub assy
(LCD801)
The LCD sub assy (LCD801) made of EPSON is substituted by the
LCD sub assy (LCD801) made of TMD as soon as the stock of the
service supply parts is digested.
Therefore, all the service supply parts are integrated into the LCD
sub assy (LCD801) made of TMD in the futures.
1. Discrimination
LCD made by EPSON
"A01065300" is marked.
LCD made by TMD
Not marked.
2
Serial number is marked.
Serial number is pasted.
2. Condition to use the LCD Confi g Setting Tool
When corresponding to the following condition, write information
on LCD that uses the LCD Confi g Setting Tool and uses it for the
main board.
• When the LCD sub assy (LCD801) made of EPSON breaks
down, and change parts are the LCD sub assy (LCD801) made
of TMD.
• When the LCD sub assy (LCD801) made of TMD breaks
down, and change parts are the LCD sub assy (LCD801) made
of EPSON.
• When nothing is displayed in LCD by the energizing confi rma-
tion after the main board is replaced.
3. Prior preparation
Procedure:
1. Following jig is prepared.
• PC (OS: since Windows XP)
• LCD Confi g Setting Tool (Confi rm the obtaining method to
each service headquarters)
2. Unzip the zip fi le of the LCD Confi g Setting Tool.
3. Copy two made folders ("LCD_EPSON" and "LCD_TMD")
onto the right under of C drive of PC.
Note: There is no problem wherever the made folder is preserved.
In "5. Use of the LCD Confi g Setting Tool", it explains assuming
that the folder is preserved right under C drive.
4. Updating the fi rmware of the main unit
(US and Canadian models only)
To use the LCD Confi g Setting Tool, the fi rmware of the main unit
must be 1.00.51 or later.
As factory side has shipped the main unit with fi rmware Version
1.00.50 to US and Canadian, please check the fi rmware version
of the main unit with test mode before using LCD Confi g Setting
Tool.
If the fi rmware version is 1.00.50, please update the fi rmware to
1.00.51.
Procedure:
1. Following jig is prepared.
• PC (OS: since Windows XP)
• F/W Updater (Confi rm the obtaining method to each service
headquarters)
2. Unzip the zip fi le of the F/W Updater to get "10051-NWZ-
S61X" folder.
3. Open the "PGImage-NWZ-S61X" folder under the folder in
step 2.
4. Start FWUpdater.exe fi le.
5. Select "I agree." and click next button.