Table of Contents
Advertisement
Service Conditions (cont'd)
6.
TOLL DENIAL/TOLL DIVERSION [T-6] and TOLL RESTRICTION-3/6-DIGIT [T-7] may or may
not be applied to SPEED CALLING, as desired.
7.
LEAST-COST ROUTING-3/6-DIGIT [L-5] may be provided via SPEED CALLING-STATION
access.
8.
Each user of an individual station equipped with this feature can program a personal speed
calling numbers, via the single-line telephone.
9.
If SPEED CALLING-STATION is assigned to a Local Processor, SPEED CALLING-GROUP [S-
23] shares the same memory tables. Therefore, careful consideration should be given when
programming.
10. SPEED CALLING-STATION data will be retained in memory, even if the system is reinitialized
or in the event of a power failure, by means of a hard disk for a system.
11. A pause may be programmed, using the "
available. Rotary type phones cannot store a pause. A pause lasts 2.8 seconds.
12. It is not necessary to erase a stored number in order to store another number. The second
number replaces the first.
13. When a caller places a call via Outgoing Call Alternative (OGCA), and when the first outgoing
route and the station setting SPEED CALLING - STATION are restricted, this service cannot be
set. In this case, the service can be set via the following procedure:
a.) assign a dummy route,
b.) clear the restriction between the dummy route and all the stations,
c.) assign the dummy route as the first route of OGCA.
Interactions
1.
Blocks are not assigned sequentially (1-100), but are assigned as a quantity of blocks in the
AISA command. These quantities will never exceed the value of 10.
2.
If one block is assigned, the Abbreviated Call Code will be digits 0-9. If two blocks are assigned,
the Abbreviated Call Code will be digits 00 - 19. If three blocks are assigned, the Abbreviated
Call Code will be digits 00 - 29, and so on, to a maximum of 10 blocks with Abbreviated Call
Codes 00 - 99.
3.
Only the Master Station will be allowed to use the SPEED CALLING-ASSIGN access code.
When assigning the abbreviated SPEED CALLING access code and number, a delay of 6-8
seconds will occur until Service Set Tone is returned.
4.
Only those stations assigned as Slave stations are considered to be members of the SPEED
CALLING-GROUP.
5.
Stations of a SPEED CALLING-GROUP (INDIVIDUAL) must be in the same Module Group
(MG). Error 0238, "MG number of MY-Line/Master station mismatch" is displayed.
6.
SPEED CALLING-INDIVIDUAL requires the assignment of senders, route 905. See
UNIVERSAL SENDER [U-3].
7.
OUTGOING TRUNK QUEUING [O-2]. This feature may be used with SPEED CALLING-
INDIVIDUAL (GROUP) if all trunks are busy.
8.
ROUTE ADVANCE [R-6] and LEAST-COST ROUTING-3/6 DIGIT [L-5] may be used with this
feature. The ASPA access code to either ROUTE ADVANCE [R-6] or LEAST-COST ROUTING-
3/6 DIGIT [L-5] will be stored in the memory of the SPEED CALLING-GROUP number.
NEAX2400 ICS Business Features and Specifications
NDA-24143, Issue 4
Speed Calling - Station
*
" key of a PB pad. This will take one of the 24 digits
S-21
Page 475
Advertisement
Table of Contents
