Adding / Checking Engine Oil (See Fig 4)
• Place generator on a level surface.
•
Remove the crankcase dipstick to ensure you do not overfill the engine.
•
Insert a funnel into the crankcase dipstick hold and carefully add 4-Cycle engine oil (SAE10W- 40 CD) to empty reservoir
until oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
•
Be sure to replace dipstick before attempting to start the engine.
•
To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without rethreading.
CAUTION!
You must add engine oil before first operating this generator. Always checkengine oil level
W W C AUTION!
before each operation.
Adding Fuel (See fig 5)
•
Set generator on a clean and level surface in an area that is well ventilated.
•
Remove fuel Fill cap..
•
Insert a funnel into the fuel tank and carefully pour diesel into
the tank until fuel level reaches 2 inches below the
top of the neck. Be careful not to overfill the tank to
provide space for fuel expansion.
ASSEMBLY
Fig 4
12
Fig 5