Chamberlain EL1SS Installation And Programming Manual page 20

INTRODUCTION
DIRECT COMMANDS FROM THE KEYPAD
KEYSTROKES
User Code + 1
User Code + 2
AUDIO FEEDBACK FROM THE EL1SS:
1 Low Tone Beep = Failure
2 Two High Tone Beeps = Valid sequence
3 Low Tone Beep = Error or invalid sequence
NOTE: Use the STAR Key "*" to cancel any input.
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high tone). Stop and go
keystrokes will result in negative tones (low single and triple fail tones).
TELEPHONE PROGRAMMING
PROGRAMMING NUMBER
**01
**02
**03
**06
**07
**#8
**10
**13
**14
**15
#*16
*# Call Forwarding
Number #
INSTALLATION
ACTION
Triggers Relay 1
Triggers Relay 2
DESCRIPTION OF TASK
Enable Call Forwarding
Disable Call Forwarding
Enable Intercom Mode
Verify Call Forwarding Number
(Via Caller ID)
Enable Telco Mode
Erase Call Forwarding Number
Adjust Ring Count
Enable Alternate DTMF Programming
Enable Standard (Long) Ring Tone
Enable Alternate (Dual) Ring Tone
Disable Alternate DTMF Programming
Enter Call Forwarding Telephone Number
TESTING
FACTORY SETTING
Disabled
Disabled
Disabled
Disabled
5
Disabled
Enabled
Enabled
19
PROGRAMMING
PROGRAMMING PROCEDURE
**01
**02
**03
**06
**07
**#8
**10 + Ring Count (2-5)
**13
**14
**15
**16
*# + Telephone Number (Up to
14 digits) + #