Mains Voltage; Power Amplifier; Input Sensitivity - Peavey TourTM Series Operating Manual

Tour 450

Mains Voltage:

120 VAC 60 Hz - 6 amp fuse
230 VAC 50/60 Hz - 3.15 amp fuse
100 VAC 50/60 Hz - 8 amp fuse
Power Consumption:
600 W

Power Amplifier

Protection:
DDT™ speaker protection
with defeat switch
Short Circuit protection
Thermal protection circuit
Cooling fan failure protection circuit
Current limit protection circuit
DC output protection circuit
Minimum Load:
4 Ω

Input Sensitivity:

600 mVRMS
Output Jacks:
Two 1/4" Speakon® combination
jacks in parallel
All specifications tested with mains voltage maintained at nominal level.
Tour Series Specifications
™
Power Output:
300 w, 48.9 VRMS/8 Ω
450 w, 42.4 VRMS/4 Ω
Noise:
> 100 dB below full power @ 8 Ω
typically -105 dB
Preamplifier Specifications
Settings (
Pre gain: 4 (12 o'clock)
Bright: Out
Mute: out
Contour: 0 (fully counterclockwise)
Low: 0
High: 0
Low Cut: Out
Graphic EQ: All sliders set to center
EQ Bypass: Out
Post Gain: 10 (fully clockwise)
Octaver: MIN
(fully counterclockwise)
Octaver Defeat: Out
DDT™: Active
Features and specifications subject to change without notice.
:
unless otherwise stated)
12
Input Sensitivity (High Gain):
Nominal Input: 616 mVRMS
Minimum Input: 34.1 mVRMS
Maximum Input: 2.3 VRMS
(maximum signal at input before clipping)
Input Sensitivity (Low Gain):
Nominal Input: 1.0 VRMS
Minimum Input: 59.3 m VRMS
Maximum Input: 7.2 VRMS
(maximum signal at input before clipping)
Tuner Send:
Buffered from input jack with no
equalization
D.I. XLR Output:
Buffered from input jack with no
equalization
Failsafe D.I. Backup:
48 v phantom power
Weight:
21.8 lb.
Dimensions (h x w x d):
3.875 x 19.00 x 12.50