Issue - Nokia 6267 RM-210 Service Manual

RM-210
Service Devices and Service Concepts

Issue 1

RJ-93
RJ-93 is used as a rework jig for the engine module.
This stencil takes the front end module (FEM) or power amplifier (PA)
module for spreading the soldering paste to the component. Must be
used together with the ST-40 stencil.
SPS-1
The SPS-1 allows spreading of solder to the LGA components pads over
the rework stencils.
SRT-6
SRT-6 is used to open phone covers.
SS-46
SS-46 acts as an interface adapter between the flash adapter and
FPS-10.
SS-62
• generic base for flash adapters and couplers
• SS-62 equipped with a clip interlock system
• provides standardised interface towards Control Unit
• provides RF connection using galvanic connector or coupler
• multiplexing between USB and FBUS media, controlled by VUSB
COMPANY CONFIDENTIAL
Copyright © 2007 Nokia. All rights reserved.
Rework jig
Soldering Paste
Spreader
Opening tool
Interface adapter
Generic flash adapter
base for BB5
Page 2 –11