To Adjust Switch Position Of Auto Thread Cutter - Singer s18 Service Manual

TO ADJUST AUTO THREAD CUTTER SWITCH POSITION
Step3 Switch
SP
OFF
(Sewing mode)
The driving arm (1) is
raised.
Driving arm (1)
Switch
Setscrew (A)
FL CL DD
UP OFF UP
Display (C)
Driving arm
(Cutting mode)
The driving arm (1) is
lowered.
1. While pressing the needle up/down and lock
stitch buttons, turn the power switch on. Press
the number "9" within 3 seconds.
2. Remove the machine base and auto thread
cutter cover (refer to pages 2 and 3).
3. Set the needle bar at the lowest position.
4. Loosen the setscrew (A) and adjust the position
of the switch (B) as follows:
* When the driving arm (1) is lowered, the
display (C) shows "ON".
* When the driving arm (1) is raised, the
display (C) shows "OFF".
5. Attach the machine base and auto thread cutter
cover.
(1)
37