To Adjust Presser Bar (Direction And Height) - Singer s18 Service Manual

TO ADJUST DIRECTION OF PRESSER BAR AND ITS HEIGHT
When the presser foot is lifted, the distance between the surface of the needle plate and the bottom of the
zigzag foot should be 6mm as shown in Fig 1.
When the presser bar is lowered, the presser foot should be parallel with the holes for the feed dogs as
shown in Fig. 2.
Hexagonal socket
screw (A)
Presser bar
lifter
Zigzag foot
Fig. 1
Holes for
feed dogs
Fig. 2
[ To adjust ]:
1. Remove the face plate (refer to page 1).
2. Lift the presser bar.
3. Attach the face plate.
Hexagonal
socket
screw (A)
6mm
To be
parallele with
holes for
feed dogs
16
Loosen the hexagonal socket screw (A).
Adjust the direction and height of the presser bar.