Table of Contents
Advertisement
Manual Tuning.
1. To carry out Manual tuning in FM mode press the BAND button so the display
shows the tuner is in FM mode.
2. Press either the UP or DOWN buttons to change the FM frequency by
0.05MHz steps to the desired frequency, or Hold the UP or DOWN buttons for
2 seconds to skip to the next available radio station.
Direct Tuning.
1. To carry out Direct tuning in FM mode press the BAND button so the display
shows the tuner is in FM mode.
2. Press the DIRECT button (---.-- will be displayed), use the number keys (1-10/0)
to select the desired frequency then press the DIRECT button again.
(Note: If the frequency selected is outside the tuners range then ERROR will be
displayed).
Storing A Memory Pre-Set Manually:
1. Tune into desired AM or FM radio station frequency.
2. Press the MEMORY button , a memory preset channel will now be flashing
(CH01) on the LCD screen.
3. Use the UP or DOWN buttons to select the required Pre-Set location, then press
MEMORY button again to finalise the selection.
(Note: If the process is left for 5 seconds without finalising, the station will not be
stored in the memory location and the process will need to be restarted)
Selecting A Memory Pre-Set:
1. For memory pre-sets in locations 1-10 you can use the number keys to go
directly to you stored radio station.
2. Or you can use the ME-UP or ME-DOWN buttons to skip through each memory
location.
3. For FM mode only, you can skip by 10 memory locations by using the +10/--
button on the remote control.
7
Advertisement
Table of Contents
