Table of Contents
Advertisement
Change Between AM & FM Modes:
1. To change receiving mode from AM to FM, simply press the BAND button.
Tuning In AM Mode:
Auto Tune & Storing.
1. To carry out Auto tuning in AM mode press the BAND button so the display
shows the tuner is in AM mode.
2. Press and Hold the ASM button for 2 seconds. The auto-scan function will search
and store all available AM radio stations in the memory presets.
3. Any previously stored AM stations will be replaced when using this mode.
Note: If no stations are stored then the signal is too weak, either reposition the
Loop antenna and try again or use an external antenna.
Manual Tuning.
1. To carry out Manual tuning in AM mode press the BAND button so the display
shows the tuner is in AM mode.
2. Press either the UP or DOWN buttons to change the AM frequency by 9KHz steps
to the desired frequency, or Hold the UP or DOWN buttons for 2 seconds to skip
to the next available radio station.
Direct Tuning.
1. To carry out Direct tuning in AM mode press the BAND button so the display
shows the tuner is in AM mode.
2. Press the DIRECT button (---- will be displayed), use the number keys (1-10/0)
to select the desired frequency then press the DIRECT button again. (Note: If
the frequency selected is outside the tuners range then ERROR will be displayed).
Tuning In FM Mode:
Auto Tune & Storing.
1. To carry out Auto tuning in FM mode press the BAND button so the display
shows the tuner is in FM mode.
2. Press and Hold the ASM button for 2 seconds. The auto-scan function will
search and store all available FM radio stations in the memory presets.
3. Any previously stored FM stations will be replaced when using this mode.
Note: If no stations are stored then the signal is too weak, either reposition the
Loop antenna and try again or use an external antenna.
Functions & Settings
6
Advertisement
Table of Contents
