Table of Contents
Advertisement
PROCEDURE FOR 45° ANGLE INSTALLATION W/O STUDS
Note
If the anti-vibration spring position has been changed and verified for 45° angle mounting (as shown on page 4), start with step 2.
1
Set the 2 anti-vibration springs to position "45°".
3
Determine the mounting location, and drill four mounting
holes.
Never mount the unit near the fuel tank.
6
DRILL HOLES 4MM IN DIAMETER
2
Attach bracket to each side of the unit, using the machine
screws with flat and lock washers (M4x 10).
In the 45 position, use holes 1 and 3' as shown at left.
NOTE: Use masking tape to cover unused
mounting holes on sides of unit.
BRACKET
(Left Side)
MACHINE SCREW WITH FLAT
AND LOCK WASHERS (M4 x 10)
4
Mount the unit in place, using four self-tapping screws
(M5 x 12).
Use RTV (silicone sealer) on screw threads and around
the holes to prevent moisture intrusion.
BRACKET
(Left Side)
BRACKET
(Right Side)
SELF-TAPPING SCREWS
(M5 x 12)
BRACKET
(Right Side)
Advertisement
Table of Contents
