Audiovox SP-10CD Installation Manual
  1. Manuals
  2. Brands
  3. Audiovox Manuals
  4. CD Player
  5. SP-10CD
  6. Installation manual
Audiovox SP-10CD Installation Manual

Audiovox SP-10CD Installation Manual

Audiovox 10-disc cd changer installation guide
Hide thumbs Also See for SP-10CD:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
SP-10CD
MODEL SP-10CD
10-DISC CD CHANGER
INSTALLATION MANUAL

Advertisement

Table of Contents
loading

Related Manuals for Audiovox SP-10CD

Summary of Contents for Audiovox SP-10CD

  • Page 1 SP-10CD MODEL SP-10CD 10-DISC CD CHANGER INSTALLATION MANUAL...

  • Page 2: Packing List

    PACKING LIST MAIN UNIT INSTALLATION PARTS Bracket (L) 1 pc. Self-tapping screw (M5 x 12) 4 pcs. OTHER ACCESSORIES CD Magazine 1 pc. Changer Bracket (R) Hexagonal bolt with washer 1 pc. Seals (A) 1 pc. Index seal sheet Installation Manual 1 pc.

  • Page 3: Before Installing The Unit

    BEFORE INSTALLING THE UNIT Transport Lock Screws The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation. After removing the transport lock screws, place the supplied seals (A) over the screw holes.

  • Page 4: Installation

    INSTALLATION The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (left and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.
  • Page 5 PROCEDURE FOR VERTICAL INSTALLATION Note If the anti-vibration spring position has been changed and verified for vertical mounting (as shown on page 3), start with step 2. Set the 4 anti-vibration springs to position "V". position "V" Determine the mounting location, and drill four mounting holes.
  • Page 6 PROCEDURE FOR 45° ANGLE INSTALLATION Note If the anti-vibration spring position has been changed and verified for 45° angle mounting (as shown on page 3), start with step 2. Set the 4 anti-vibration springs to position "45°". Determine the mounting location, and drill four mounting holes.
  • Page 7 VEHICLE WIRING Mating 8-pin DIN socket on rear of compatible radio chassis (see note 1 below). NOTE: 1. Check with your Audiovox car audio dealer to be Car Stereo with CD Changer Controls sure your stereo is directly compatible with this CD changer.
  • Page 8 © 1999 AUDIOVOX CORP., HAUPPAUGE, NY Printed in China 128-5542...

Table of Contents