Honda legend Owner's Manual page 553

09/01/28 18:46:05 32SMG631_553
Honda TRK (For some types)
NOTE:
The power supply of the air
compressor is limited to your
vehicle's 12 volt DC accessory socket.
548
Taking Care of the Unexpected
Directions
Before using the air compressor,
drive your vehicle to the road
shoulder and stop in a safe place that
is far away from the traffic lanes.
Step 1.
Remove the valve cap from a flat
tyre and securely connect the air
compressor hose to the valve.
Step 2.
Connect the power plug of the air
compressor to the socket of the
cigarette lighter.
Step 3.
Turn the ignition switch to the
ACCESSORY (I) position. Turn on
the air compressor switch and
inflate the tyre to the specified air
pressure. Check the tyre pressure
by using the air pressure gauge on
the compressor.
Turn off the switch on the air
compressor before checking the air
pressure.
Step 4.
When the tyre is inflated to
specified air pressure, disconnect
the power plug from the cigarette
lighter socket. Make sure not to
allow air to leak from the tyre.
Then install and tighten the valve
cap securely.