Table of Contents
Advertisement
Administration
To run the network camera server, it is required to access the "Administrator's Page" to perform the settings.
Refer to this chapter on how to access the "Administrator's Page", and the settings required to be set.
How to Display the "Administrator's Page"
1. Start up the web browser and display the "TOP
MENU" of the network camera server.
http://(server address)/s3/American/
The server address differs depending on the
user environment.
2. Click the [Administrator's Page] button.
The authentication dialog window will be displayed.
The "Administrator's Page" can be displayed by
entering the following address. In this case, the
authentication dialog window will also be displayed.
http://(server address)/s3/American/cfg
Note: To perform the settings of the network cam-
era server, use Internet Explorer 5.5 SP2 or 6.0
SP1. If other browsers are used, the settings
cannot be performed correctly.
3. Enter a user name and a password, and then
click the [OK] button.
User name: Enter the user name belonging to the
"admin" group.
43
Password: Enter the password corresponding to
the entered user name.
Just after installation, only the user name "admin"
is registered in the "admin" group. The password
for the user name "admin" is the password entered
when installing the WV-AS710.
When the user is authenticated, the
"Administrator's Page" will be displayed.
4. Click the desired button in the "Setting Menu".
Some types of "Setting Menu" have two or more
tabs. Click the desired tab to display the menu to
be set.
5. Click the [Save] or [Save...] button on each
menu page to save the changed settings.
A dialog window for confirmation will be displayed.
Follow the displayed instructions to complete the
settings.
Advertisement
Table of Contents
