Epson LX-810 User Manual page 228

Options
Problem
Solution
Using the pull tractor
with the push tractor
(continued).
Several lines of
space occur in the
printout.
Skip over perforation
is set, hut does not
work.
The paper may have too much slack.
Adjust the position of the sprockets to take
up any slack along the width of the paper.
Remove slack lengthwise by pressing in and
rotating the pull tractor feed knob on the
right. Refer to 5-29.
The paper thickness lever may not be set
correctly. Set the paper thickness lever to
match the thickness of your paper. Refer
to 2-22.
The paper may not meet the specifications.
Check that your paper is of the proper
size, weight, and thickness. Refer to 8-3.
Skip over perforation may be set. Set DIP
switch 2-3 to OFF.
You may have changed the DIP switches
with the power on. To make new DIP
switch settings effective, turn the power
off, then on again.
7-28 Troubleshooting