Starting Online Diagnostic Tests; Displaying Online Diagnostic Tests And Test Results - Cisco Catalyst 3560-X Software Configuration Manual

Chapter 1 Configuring Online Diagnostics

Starting Online Diagnostic Tests

After you configure diagnostic tests to run on the switch, use the diagnostic start privileged EXEC
command to begin diagnostic testing.
Use this privileged EXEC command to manually start online diagnostic testing:
Command
diagnostic start switch number
test {name | test-id | test-id-range
| all | basic | non-disruptive}
After starting the tests, you cannot stop the testing process.
This example shows how to start a diagnostic test by using the test name:
Switch# diagnostic start switch 2 test TestInlinePwrCtlr
This example shows how to start all of the basic diagnostic tests:
Switch# diagnostic start switch 1 test all

Displaying Online Diagnostic Tests and Test Results

You can display the online diagnostic tests that are configured for the switch or switch stack and check
the test results by using the privileged EXEC show commands in
Table 1-1 Commands for Diagnostic Test Configuration and Results
Command
show diagnostic content switch [number | all]
show diagnostic status
show diagnostic result switch [number | all]
test {name | test-id | test-id-range | all} [detail]]
show diagnostic switch [number | all]
OL-25303-03
Purpose
Start the diagnostic tests.
The switch number keyword is supported only on Catalyst 3750-X switches. The range is
from 1 to 9.
You can specify the tests by using one of these options:
name—Enter the name of the test. Use the show diagnostic content privileged EXEC
•
command to display the test ID list.
test-id—Enter the ID number of the test. Use the show diagnostic content privileged
•
EXEC command to display the test ID list.
test-id-range—Enter the range of test IDs by using integers separated by a comma
•
and a hyphen. For more information, see the diagnostic start command in the
command reference for this release.
all—Use this keyword when you want to run all of the tests.
•
• basic—Use this keyword when you want to run the basic test suite.
• non-disruptive—Use this keyword when you want to run the non-disruptive test
suite.
Purpose
1
Display the online diagnostics configured for a switch.
Display the currently running diagnostic tests.
1
[detail | Display the online diagnostics test results.
1
[detail] Display the online diagnostics test results.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Running Online Diagnostic Tests
Table 1-1:
1-5