Chery A1 2008 Operating Instructions Manual page 48

INTRODUCTION OF FUNCTIONS AND DESCRIPTION OF INDICATIONS OF THE VEHICLE
Switch between
Beam/Low Beam
Headlamp
When headlamp switch is at the "Low
Beam Light" position, i.e. the low beam
light is turned on, pull the handle forward
to get over the stress point and shift in
high beam. When high beam is turned on,
the high beam indicator light in the
instrument will also light. Moving the
handle towards the steering wheel to its
original position can return to the low
beam lamp.
High FLASHING
of HEADLAMP
During driving, if it is necessary to flash
the headlamp, just moving the handle
towards the steering wheel to the resistant
point, and then release the handle to make
it auto return. Repeating this operation can
flash the headlamp continuously.
Low Beam Electric
Control Switch ( )
It locates at right side of fog lamp switch;
through the adjusting knob, height of light
OF
beam of low beam light can be controlled.
There are four figures-"0, 1, 2, 3" on the
knob; while dialing from 0 to 3 in turn,
light beam of the low beam light will
become lower and lower. Note that you
should dial one figure at intervals of 1
minute or so when using. If you dial too
quickly, the electric control switch may
not work.
Front and
Lamp Switches
Rear Fog