Alpine Opera Eco Installation Manual page 36

7.3 Checking the Initial Fault Safety
To check the safety equipment, proceed as follows:
The switching positions I and II are testing settings used only to check the safety during
the annual inspection, or after repair work, or each time bed is put into service again.
• Setting switch position 4 (padlock symbol open
slightly raised position.
• Setting switch position 3 (padlock symbol closed
adjustment buttons, no motorised adjustments should be possible.
• Set switch on the back of the handset to testing position 1 (symbol I).
• When operating the adjustment buttons, no motorised adjustments should be
possible.
• Set switch on the back of the handset to testing position 2 (symbol II).
• When operating the adjustment buttons, no motorised adjustments should be
possible.
Eco/Classic Installation Guide and Technical Specification
35
). Move all bed adjustments to a
). When operating the