Mattress holders
Clip in place the mattress holders (OP017), 2 slats
down from the top of the
backrest, and 2 slats up
from the bottom of the
legrest. Repeat for the
other side of the bed.
Test functions
Connect the bed to mains power. Test the controls
on the bed are working correctly, by performing the
following steps:
I.
Test the height adjustment
II.
Test the trendelenburg feature
III.
Test the anti-trendelenburg feature
IV. Lower the bed into the lowest position
V.
Test the backrest elevation
VI. Test the legrest elevation
Eco/Classic Installation Guide and Technical Specification
15
2. Installation and Commissioning
15
16