Operation; Storage And Transport - Siemens SITRANS LVL100 Operating Instructions Manual

Packaging
Transport
Transport inspection
Storage

Storage and transport

temperature
SITRANS LVL100 l CONTACTLESS ELECTRONIC SWITCH
Data for power supply are specified in chapter "Technical
data".

3.3 Operation

The switching status of SITRANS LVL100 can be checked with
closed housing (signal lamp). Products with a density > 0.7 g/
cm³ (0.025 lbs/in³) can be detected.
3.4 Storage and transport
Your instrument was protected by packaging during transport.
Its capacity to handle normal loads during transport is assured
by a test according to DIN EN 24180.
The packaging of standard instruments consists of environ-
ment-friendly, recyclable cardboard. For special versions, PE
foam or PE foil is also used. Dispose of the packaging material
via specialised recycling companies.
Transport must be carried out under consideration of the notes
on the transport packaging. Nonobservance of these instruc-
tions can cause damage to the device.
The delivery must be checked for completeness and possible
transit damage immediately at receipt. Ascertained transit
damage or concealed defects must be appropriately dealt
with.
Up to the time of installation, the packages must be left closed
and stored according to the orientation and storage markings
on the outside.
Unless otherwise indicated, the packages must be stored only
under the following conditions:
Not in the open
l
Dry and dust free
l
Not exposed to corrosive media
l
Protected against solar radiation
l
Avoiding mechanical shock and vibration
l
Storage and transport temperature see "Supplement -
l
Technical data - Ambient conditions"
Relative humidity 20 ... 85 %
l
Product description
9