White Ratio (Balance) Adjustment; Calibration And Manual Setting For Wb Adjustment - Samsung UE32EH5 SERIES Service Manual

4. Troubleshooting

4-5. White Ratio (Balance) Adjustment

1. You can adjust the white ratio in factory mode (1:Calibration, 3:White-Balance).
2. Since the adjustment value and the data value vary depending on the input source, you have to adjust these in CVBS,
Component 1 and HDMI 1 modes.
3.
The optimal values for each mode are configured by default. It varies with Panel's size and Specification.
• Equipment : CS-210
• Pattern: MIK K-7256 #92 "Flat W/B Pattern" as standard
• Altenate Equipmet : CA200& anyone Master supported
pattern#92(refer to right photo)
• Use other Equipment only after comparing the result
with that of the Master equipment.
• Set Aging time : 60 min

Calibration and Manual setting for WB adjustment

• HDMI : Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
• COMP: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (720p)
• CVBS: Calibration at #24 Chessboard Pattern Manual adjustment at #92 pattern (NTSC)
Note
If finishing in HDMI mode, adjustment coordinate is almost same in AV/COMP mode.
4-20