Assembly And Set-Up - Razor A5 Owner's Manual

ASSEMBLY AND SET-UP

Unfolding the Scooter for First Time Use
1
To release the folding mechanism,
place the scooter on the ground, put
one foot on the deck plate and pull
the Anti-Rattle knob up. Raise T-bar
up until it is securely locked in the
upright position.
2
Insert and secure the left
and right handlebars by pressing
the spring-loaded buttons and
inserting them into the T-bar.
Adjusting the Handlebar Height
1
To adjust the height of the
handlebars, open the quick-release
lever and slide the T-bar to the
desired position and resecure the
quick release lever to lock into
place. When the T-bar is raised to
the maximum height, depress the
push button located directly below
the quick release lever to unlock
the T-bar.
Note: The Anti-Rattle knob
is spring-loaded and will
automatically lock in the upright
position when fully upright.
3
Make certain BOTH handlebars
are properly locked onto the T-bar.
Note: The tension of the quick-
release lever can be adjusted by
manually tightening or loosening
the Allen bolt. Be careful not to
over-tighten. You should always
be able to open and close the
quick-release lever by hand and the
T-bar should slide freely when the
quick-release is open.
Note: To activate the anti-rattle
feature twist the knob to the right
to tighten. Please note there is no
need to over tighten.
3
WARNING:
Keep fingers clear of the pivoting
mechanism when folding or
unfolding the scooter. Make sure
others are standing clear.
WARNING: Failure to
properly engage the spring-loaded
buttons may cause the handlebars
to dislodge while riding and may
cause you to lose control and
fall. When correctly engaged the
handlebars will not rotate nor will
they move sideways. Note that
when properly engaged, the spring-
loaded buttons are clearly visible in
the holes on the T-bar.
WARNING: Failure to
properly secure the quick-release
lever may cause the T-bar to
telescope up or down while riding
and may cause you to lose control
and fall.