Suzuki DR·Z400SM Owner's Manual page 51

1----­ Turn Signal Light
To replace the turn signal light
bulb, follow these directions:
CAUTION
Oil from your skin may damage
the headlight bulb or shorten
its life.
I
Grasp the new bulb with a
clean cloth.
~~I~~~
if
Headlight Beam Adjustment
The headlight beam can be
adjusted both horizontally and
11.
Remove the screw and take off
vertically if necessary. the lens.
~.~t!)
2. Push in on the bulb, turn it to
the left, and pull it out.
To adjust the beam vertically:
3. To fit the replacement bulb
Turn the adjuster 1 clockwise or
push it in and turn it to the right
counterclockwise.
while pushing.
To adjust the beam
horizontally: CAUTION
Turn the adjuster 2 clockwise or
Overtightening the screws
counterclockwise.
when reinstalling the lens may
cause the lens to crack.
Tighten the screws only until
they are snug.
Brake LightlTaillight FUSE
To replace the brake light/taillight
01'
bulb, follow the procedure below
~--\
.
~;"i'o1.
~:y
U~---if
'
If there is any electrical system
failure, first check the fuse. In
1. Remove the two screws and
I
case the fuse blows, there is a
remove the lens. 20A spare fuse.
CAUTION
Installing a fuse of incorrect
rating or using aluminum foil
"[,,,-c--
J-"' " ,
,'I"
~\
, l l f '
or wire instead of a fuse may
1
"lJ. " '0
• '
seriously damage the electrical
,
-if~
system.
Always replace a blown fuse
with a fuse of the same type
2. Push in on the bulb, turn it to
the left, and pull it out. and rating. If the new fuse
3. To fit the replacement bulb,
blows in a short time, consult
push it in and turn it to the right
your Suzuki dealer or a quali­
while pushing.
fied mechanic immediately.
CAUTION
Overtightening the screws
when reinstalling the lens may
cause the lens to crack.
Tighten the screws only until
they are snug.
7-38
7-39