Description; Specifications; Specifications - Torque - Generator - Dodge dakota 2002 Service Manual

8F - 20 CHARGING
CHARGING (Continued)
• a faulty or improperly adjusted switch that
allows a lamp to stay on. Refer to Ignition-Off Draw
Test in 8, Battery for more information.
INSPECTION
The PCM (Powertrain Control Module), or ECM
(Diesel) monitors critical input and output circuits of
the charging system, making sure they are opera-
tional. A Diagnostic Trouble Code (DTC) is assigned
to each input and output circuit monitored by the
On-Board Diagnostic (OBD) system. Some charging
system circuits are checked continuously, and some
are checked only under certain conditions.
Refer to Diagnostic Trouble Codes in; Powertrain
Control Module; Electronic Control Modules for more
DTC information. This will include a complete list of
DTC's including DTC's for the charging system.
To perform a complete test of the charging system,
refer to the appropriate Powertrain Diagnostic Proce-
dures service manual and the DRB scan tool. Per-
form the following inspections before attaching the
scan tool.
(1) Inspect the battery condition. Refer to 8, Bat-
tery for procedures.

SPECIFICATIONS

GENERATOR RATINGS
TYPE
DENSO
DENSO
BOSCH
BOSCH
DENSO
DENSO
BOSCH

SPECIFICATIONS - TORQUE - GENERATOR /

CHARGING SYSTEM

DESCRIPTION

Generator Mounting Bolts - 5.7L
Generator Support Bracket
Bolt/Nuts - 5.7L
Generator Mounting Bolts - 8.0L
Generator Upper Mounting Bolt -
5.9L Diesel Engine
Generator Upper Mounting Bolt -
5.9L Gas Engine
PART NUMBER
56029700AA
56029701AA
56041120AC
56028238AB
56028560AA
56028696AA
56028699AA
N·m
41
41
41
41
41
(2) Inspect condition of battery cable terminals,
battery posts, connections at engine block, starter
solenoid and relay. They should be clean and tight.
Repair as required.
(3) Inspect all fuses in both the fuseblock and
Power Distribution Center (PDC) for tightness in
receptacles. They should be properly installed and
tight. Repair or replace as required.
(4) Inspect generator mounting bolts for tightness.
Replace or tighten bolts if required. Refer to the Gen-
erator Removal/Installation section of this group for
torque specifications.
(5) Inspect generator drive belt condition and ten-
sion. Tighten or replace belt as required. Refer to
Belt Tension Specifications in 7, Cooling System.
(6) Inspect automatic belt tensioner (if equipped).
Refer to 7, Cooling System for information.
(7) Inspect generator electrical connections at gen-
erator field, battery output, and ground terminal (if
equipped). Also check generator ground wire connec-
tion at engine (if equipped). They should all be clean
and tight. Repair as required.
RATED SAE AMPS
136
136
136
136
136
136
136
Ft. Lbs.
30
30
30
30
30
DR
ENGINES
3.7L / 4.7L
5.9L Gas
3.7L / 4.7L
5.9L Gas
8.0L
5.7L Gas/5.9L Diesel
5.7L Gas/5.9L Diesel
In. Lbs.
-
-
-
-
-