Dodge dakota 2002 Service Manual page 164

DR
DIFFERENTIAL-TRAC-LOK (Continued)
(7) Position a small screw driver in slot of
Threaded Adapter Disc C-6960-1 (Fig. 40) to prevent
adapter from turning.
Fig. 40 THREAD ADAPTER DISC
1 - SOCKET
2 - SLOT IN DISC
3 - SCREWDRIVER
4 - LOWER DISC
5 - THREADED ROD
6 - UPPER DISC
(8) Install Forcing Screw C-6960-4 and tighten
screw to 122 N·m (90 ft. lbs.) maximum to compress
Belleville springs in clutch packs (Fig. 41).
Fig. 41 COMPRESS BELLEVILLE SPRING
1 - TORQUE WRENCH
2 - FORCING SCREW
3 - DIFFERENTIAL CASE
(9) With a feeler gauge remove thrust washers
from behind the pinion gears (Fig. 42).
Fig. 42 PINION GEAR THRUST WASHER
1 - THRUST WASHER
2 - FEELER GAUGE
(10) Insert Turning Bar C-6960-2 into the pinion
mate shaft hole in the case.
(11) Loosen Forcing Screw in small increments
until clutch pack tension is relieved. Then turn the
case with the turning bar (Fig. 43).
Fig. 43 TURNING BAR
1 - PINION GEARS
2 - TURNING BAR
(12) Rotate differential case until the pinion gears
can be removed.
(13) Remove pinion gears from differential case.
REAR AXLE - 9 1/4 3 - 91