Telnet Console Commands - Paxar Monarch 7410 Operating Instructions Manual

T E L N E T C O N S O L E C O M M A N D S
Use this appendix to configure the print server using Telnet. You
must have a basic understanding of Telnet commands. For initial setup, do
not use Telnet. Use Auto-discover mode. Once you have the IP address,
you can use Telnet or a Web browser.
You can use Telnet if you do not have access to the WP-Admin software.
NOTE: The default port is Port 23.
To reset the unit back to factory defaults, press and hold the black button on
the print server card for about ten seconds. The LEDs will temporarily turn
off and then back on, indicating the unit is resetting.
To access Telnet console mode:
1. Start Telnet.
2. Press Enter (on your host) until you see the "#" prompt.
3. Type "access" as the password and press Enter. ("Access" is the default
password.)
4. Press Enter to by-pass the user name. You do not need to enter a
username.
Telnet Console Commands A-1
A