Installation - AEG L61470WDBI User Manual

Problem
The washing results are
not satisfactory.
You cannot set an op-
tion.
The machine does not
dry or does not dry prop-
erly:
The laundry is full of dif-
ferent coloured fluff:
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
Authorised Service Centre.

16. INSTALLATION

16.1 Unpacking
WARNING!
Remove all the packaging and the transit bolts before installing the
appliance.
Possible solution
• Increase the detergent quantity or use a different deter-
gent.
• Use special products to remove the stubborn stains before
you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Make sure that you press only the wanted button(s).
• Make sure that you have set a suitable drying programme
for your laundry.
• Make sure that you set the correct the drying time or dry-
ness degree.
• Make sure that the water tap is not turned on.
• the drain filter is not clogged.
• Make sure you have not overloaded the appliance.
The fabrics washed in the previous cycle released fluff of a dif-
ferent colour.
• Clean the clothes with a fluff remover
• The drying phase helps to eliminate some fluff.
In case of an excessive amount of fluff in the drum, refer to sec-
tion «FLUFF IN THE FABRICS».
• Thoroughly clean the empty drum, the gasket and the door
with a wet rag.
• Perform a rinse cycle.
• Put a wool or piled fabric rag inside the drum.
• Perform a drying cycle of 10 minutes.
• Remove the old wool cloth.
Now you can wash other garments.
If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the
Service.
ENGLISH 27