Accessories; Standard Accessories; Optional Accessories; Applications - Hitachi N 5008AC2 Instruction And Safety Manual

ACCESSORIES

WARNING
● Accessories other than those shown below can
lead to malfunction and resulting injuries.

STANDARD ACCESSORIES

1 Eye protection ..........................................................1
2 Allen wrench for M5 screw .......................................1
OPTIONAL ACCESSORIES ... sold separately
○ Sequential Trip Mechanism Kit
(Single Shot Parts)
○ Pneumatic Tool Lubricant
1 oz. (30 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of HITACHI.

APPLICATIONS

○ Construction work such as wall sheathing, roof
decking, subfl ooring.
○ Mobile and modular home construction.
○ Making wooden boxes, and expendable pallets.

BEFORE OPERATION

Read section titled "SAFETY" (pages 4 – 8).
Make sure of the following before operation.

WORKING ENVIRONMENT

● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
1 2
(Code No. 876762)
(Code No. 877153)
(Code No. 874042)
(Code No. 876212)
WARNING

AIR SUPPLY

● NEVER use reactive gases or
● Never connect Stapler to pressure which
potentially exceeds 200 psi (13.7 bar 14 kgf/cm
if a regulator fails.
● Never use non relieving coupler on Stapler.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Stapler.
○ Air compressors used to supply compressed air to
this Stapler must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Stapler.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Stapler and extend the Stapler life.
These units should always be used.
Filter .............The fi lter removes moisture and dirt
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
Regulator ......The regulator controls the operating
pressure for safe operation of the Stapler.
Inspect the regulator before operation
to be sure it operates properly.
Lubricator .....The lubricator supplies an oil mist to the
Stapler.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use Hitachi pneumatic tool lubricant.
English
DANGER
other bottled
Explosion may occur.
WARNING
).
2
gases.
)
2
11