To Install Shifter Lever Knob; To Check/Adjust Clutch Control Cables - Craftsman 536.886120 Owner's Manual

ASSEMBLY
TO iNSTALL SHIFTER LEVER KNOB
®
Thread the shifter lever knob onto the threaded end
of the shifterlever until it is snug againstthe hex nut
and the tip is pointed toward the engine.. Tighten the
hex nut against the bottom of the shift lever knob (See
Fig. 6).
FIG. 6
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables, Fig 7, attached to the auger clutch
lever and traction clutch lever may need to be adjusted
before you use your snow thrower_
For instructions on checking or adjusting the control
cables, see ToAdjust Clutch Control Cables paragraphon
page 19.
i llu ii i ,llllll,i llllIHN, lll
TRACTIONCLUTCH LEVER AUGER CLUTCH LEVER
OFF
CONTROLCABLES
FIG.7
,/ CHECKLIST
BEFORE YOU OPERATE AND ENJOY YOUR NEW
SNOW THROWER, WE WISH TO ASSURE THAT YOU
RECEIVE THE BEST PERFORMANCE AND
SATISFACTION FROM THIS QUALITY PRODUCT
PLEASE REVIEW THE FOLLOWING CHECKLIST:
/ All assembly instructionshave been completed
J The discharge chute rotates freely
4' No remaining loose parts in carton,
WHILE LEARNING HOW TO USE YOUR SNOW
THROWER, PAY EXTRA ATTENTION TO THE
FOLLOWING IMPORTANT tTEMS:
,f=f Engine oil is at proper lever
/J Make sure gas tank is iiiled properIy with clean, lresh,
unleaded gasoline
_J Become familiar with all controls-their location and
function, Operate controls before starting engine
9