Technical Data; Noise Emission Values; Before Putting The Machine Into Operation - EINHELL BM 200 Operating Instructions Manual

Anleitung BM 200 SPK 1 14.03.2005
GB
32. If you use a cable reel, the complete cable has to
be pulled off the reel.
33. Persons working on the machine should not be
distracted.
34. Note the direction of rotation of the motor and
blade.
35. Never dismantle the machine's safety devices or
put them out of operation.
36. Never cut workpieces which are too small to hold
securely in your hand.
37. Never remove loose splinters, chips or jammed
pieces of wood when the saw blade is running.
38. It is imperative to observe the accident
prevention regulations in force in your area as
well as all other generally recognized rules of
safety.
39. Note the information published by your
professional associations.
40. Position the blade guard so it is approx. 3 mm
above the material you want to saw.
41. Important! Support long workpieces (e.g. with a
roller table) to prevent them sagging at the end
of a cut.
42. Make sure the blade guard (10) is in its lower
position when the saw is being transported.
43. Safety guards are not to be used to move or mis-
use the machine.
44. Blades that are misshapen or damaged in any
way must not be used.
45. If the table insert is worn, replace it.
46. Never operate the machine if either the door
protecting the blade or the detachable safety
device are open.
47. Ensure that the choice of blade and the selected
speed are suitable for the material to be cut.
48. Do not begin cleaning the blade until it has come
to a complete standstill.
49. In the case of straight sawing against the parallel
stop, a push stick must be used.
Pull the power plug before beginning
any repair or maintenance work!
Wear safety goggles
Wear ear-muffs
Wear a breathing mask
18
16:37 Uhr Seite 18

5. Technical data

Voltage: 230V~50 Hz
Power: S1 180 W S2 15 min. 250 W
Ideal speed no: 1400 min
Blade length: 1400 mm
Max. blade width:
Blade speed: 900 m/min
Cutting height: 85 mm / 90°
45 mm / 45°
Throat: 200 mm
Table size: 300 x 300 mm
Tilting range of table: 0° to 45°
Workpiece size: 400 x 400 mm
Weight:

Noise emission values

Cutting
Sound pressure level LPA
87,5 dB (A)
Sound power level LWA
96,0 dB (A)
6. Before putting the machine into
operation
Make sure the machine stands securely, i.e. bolt
it to a workbench or solid base. There are two
holes for this purpose in the machine foot.
The saw table must be mounted correctly.
All covers and safety devices have to be properly
fitted before the machine is switched on.
It must be possible for the blade to run freely.
When working with wood that has been
processed before, watch out for foreign bodies
such as nails or screws etc.
Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
machine's moving parts run smoothly.
Before you connect the machine to the power
supply, make sure the data on the rating plate is
the same as that for your mains.
7. Assembly
CAUTION!
Pull out the power plug before carrying out any
maintenance, resetting or assembly work on the
bandsaw!
-1
8 mm
20 kg