Ci-V Connection Example; Data Format - Icom IC-120 Full Manual

10
CI-V INFORMATION
CI-V data setting
You can control the transceiver with the Icom
Communications Interface-V (CI-V) commands.
Set the transceiver's address, baud rate and
transceive functions. See page 7-6 for setting the
CI-V conditions using the Menu mode.

CI-V connection example

Connect the transceiver to a PC as shown below.
To use the OPC-478UC
592
clOning cable adapter
USB driver.
The driver and installation guide are supplied with the
cloning cable.
Read the guide carefully before installing the driver.
To a USB port
USB cable
OPC-478UC
OPC-592
and the OPC-
clOning cable
, you must first install a
IC-A120/IC-A120E

Data format

The CI-V system uses the following data formats.
Data formats differ, depending on the command
numbers. A data area or sub command is added to
some commands.
Controller to IC-A120/IC-A120E
q w e
FE FE 92 E0
FE FE E0 92
q w e
IC-A120/IC-A120E to controller
* The reply messages from the transceiver are the command
"FB" (OK) or "FA" (NG).
10-2
r t y
Cn Sc Data area
Cn Sc Data area
r* t y
u
FD
FD
u