Siemens FDOOT221 Technical Manual page 74
Automatic fire detectors
Hide thumbs
Also See for FDOOT221:
- Technical manual (138 pages) ,
- Building technologies (6 pages) ,
- Manualline (24 pages)
Table of Contents
Advertisement
5
Mounting / installation
Sealing kit FDBZ295
74
Building Technologies
Fire Safety
Installation
The kit is installed by hand
1. Fold the sealing lip back.
2. Insert the detector base into the sealing kit. Make sure that the opening in the
detector base lines up with the marking and opening on the rubber base.
NOTICE
Risk when piercing the rubber base with a tool!
Consequences: Leaks in rubber base
Do not use tools for piercing!
3. Push the connection wires through the rubber base from the rear.
4. Install the detector base.
5. Place a point detector or alarm sounder in the detector base.
6. Turn the point detector or alarm sounder to the right to screw it firmly into the
detector base.
7. Screw the supplied set screw into the point detector or alarm sounder until it no
longer protrudes. This step is not needed when using detector locking device
FDBZ293.
8. Fold the folded-back sealing lip over the point detector or alarm sounder.
The sealing kit is fitted.
007004_n_en_--
01.07.2012
Advertisement
Table of Contents
