Installation Of Outdoor Unit; Removal And Installation Of The Front Panel - Mitsubishi Electric SRK05CR-S Technical Manual

Removal and installation of the front panel

① Removing
• Remove the 2 set screws.
• Move the lower part of the panel forward and push
upwards to remove. (Remove the 3 latches in the upper
section.)
② Fitting
• Do remove the air filter.
• Cover the body with the front panel.
• Push the circled portion at the front.
• Tighten the 2 set screws.
• Fit the air filter. Carry out in the above order.

Installation of outdoor unit

<SRK05, 09 models>
① Make sure that the unit is stable in installation. Fix the unit to
stable base.
② Perfrom wiring, making wire terminal numbers conform to
terminal numbers of indoor unit terminal block.
③ Earth lead wire shall be longer than the other lead wires for
the electrical safety in case of the slipping out of the cord
from the anchorage.
Connecting diagram.
Power source
<SRK12 model>
① Make sure that the unit is stable in installation. Fix the unit to
stable base.
② Perfrom wiring, making wire terminal numbers conform to
terminal numbers of indoor unit terminal block.
③ Earth lead wire shall be longer than the other lead wires for
the electrical safety in case of the slipping out of the cord
from the anchorage.
Connecting diagram.
Power source
RMA012A080_091-093_EN.indb 32
Terminal on the indoor unit
L 2/N 1
L L
N
N
2
1
Terminal on the outdoor unit
Terminal on the indoor unit
L 2/N 1
L
L
N
N
2 1
Terminal on the outdoor unit
– 32 –

- -
'15 • SRK-T-171
Set screws
Terminal block
1 2
Interconnecting wire
Terminal block
1 2
Interconnecting wire
05/11/2014 11:50:41