Oppo udp-203 User Manual page 68

S E T U P M E N U O P T I O N S
NOTE

Dynamic Range Compression is applied to the analog audio output and digital audio outputs
(HDMI, Coaxial and Optical) when the audio format is set to PCM.
5. Filter Characteristics: Configure the digital filter for the audio DAC. Some customers may prefer
one type of filter over others.

– Select the Sharp Roll-off filter.
Sharp Roll-off

Short-Delay Sharp

– Select the Slow Roll-off filter.
Slow Roll-off

Short-Delay Slow

– Select the Super Slow Roll-off filter.
Super Slow
6. Speaker Configuration:
such as down-mix mode, number of speakers, their distance, size and trim level. The Speaker
Configuration menu shows an illustration of speaker placement to assist you in properly
configuring your speakers. Please refer to the Speaker Configuration section on page 64 for
details of each option.
7. Crossover: Allows you to set the Bass Management kick-in frequency for all speakers. When the
speaker size is set to Small in Speaker Configuration (see page65), bass information below this
frequency is not passed to the speakers to reduce possible distortion, and if the subwoofer is
available, bass information will be redirected to the subwoofer. When all speaker sizes are set to
Large, there is no Bass Management.

40Hz / 50Hz / 60Hz / 70Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 130Hz / 140Hz / 150Hz
/160Hz / 200Hz / 250Hz – These are the available crossover frequencies. You can press the
UP/DOWN ARROW buttons and the ENTER buttons to select it. This option applies to all
speakers (center front, surround, and surround back speakers). By default the crossover
frequency is 80Hz.
8. DTS Neo:6 Mode: Allows you to enable DTS Neo:6 audio processing and select the listening mode.
DTS Neo:6 is a digital signal processing that can expand the original stereo source to 7.0 (L, R, C,
L , R , L , R ) or 7.1 (with Bass Management) surround.
S S R R

Music – Enables DTS Neo:6 audio processing for stereo music sources.

Cinema – Enables DTS Neo:6 audio processing for digital TV box or stereo movie sources.

Off (default) – Turns off the DTS Neo:6 to keep the original audio quality.
(default) – Select the Short-Delay Roll-off filter.
– Select the Short-Delay Slow Roll-off filter.
In the Speaker Configuration menu you can configure speaker settings
63