FUNAI DRVR-B778S Service Manual page 14

Reference Notes
CAUTION 1: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1-1. Release five Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2).
1-3. Disconnect Connector (CN1505), and remove
the Front Assembly.
2. When reassembling, solder wire jumpers as shown
in Fig. D9.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. D9. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D9.
4. The DVD Mechanism & DVD Main CBA Assem-
bly is adjusted as a unit at factory. Therefore,
do not disassemble it.
Replace the DVD Mechanism & DVD Main CBA
Assembly as a unit.
(S-1)
[1] Top Cover
(S-2)
[3] Front
Bracket
(L-1)
(L-2)
(S-1)
(S-1)
Fig. D1
(S-2)
(S-3)
(L-1)
CN1505
[2] Front
Assembly
(L-1)
Fig. D2
1-6-2
[4] Jack Bracket
(S-5)
CN701
CN101
hook
*
[6] DVD
Mechanism
&
DVD Main
CBA
Assembly
*
See Reference Notes 4.
(S-4)
[5] Front
Jack CBA
Jack Earth Plate
Fig. D3
(S-5)
(S-5)
[7] Dust
Cover
Fig. D4
E9G01DC