Table of Contents
Advertisement
Troubleshooting
If you suspect something is wrong, immediately switch power off. Immediately stop using it and call the store where you purchased it.
Never try to repair the unit yourself because it is dangerous to do so.
Problem
General
No power or no sound.
Disc
Disc is inside but no sound.
Disc sound skips, tone quality is low.
Sound skips due to vibration.
Radio
Noise in broadcasts.
Preset station lost.
Error Display Messages
Display shows ERROR.
When video file initializing time is too long. File read error or file type not supported.
Possible cause
Car ignition is not on.
Cable is not correctly connected.
Fuse is blown.
Volume is set at minimum or the mute
function is on.
Disc is upside down.
Disc is dirty or damaged.
Disc is dirty or damaged.
Mounting angle is over 30°.
Unstable mounting.
Station is too far, or signals are too weak.
Battery cable is not correctly connected.
Disc is dirty, damaged or upside down.
Solution
Turn your car's key to ACC or ON.
Check connection.
Replace fuse.
Check the volume or switch the mute function off.
If the above solutions cannot help.
Press the RESET button.
Place disc in the correct direction, and the label side up.
Clean disc or change another disc.
Clean CD or change another CD.
Adjust mounting angle to less than 30°.
Mount the unit securely with the mounting parts.
Select other stations of higher signal level.
Connect the battery cable to the terminal that is always live.
Press
to eject the disc.
Press SRC to exit. Then press SRC to play disc again.
19
Hide quick links:
Advertisement
Table of Contents
