SMC Networks SMC2655W User Manual page 10

The MAC address filtering section, you can decide which wireless
devices are allowed to connect to the Access Point by adding the
MAC address of the allowed clients. Wireless devices that are not in
the table will be effectively denied access. You can enter a maximum
of 32 addresses.
Check the [Enable MAC access control] option, and enter the MAC
address of the allowed clients. The format is 12 hexadecimal digits
(e.g. - 0050BACA6BBC). After you have finished entering the address,
click the [ADD] button. Then press the [Apply] button in the bottom
right-hand corner to activate the MAC Filtering.
To view the utility version or firmware version, you can go to the
[About] section.
17
Figure 1.7
The table below shows all the default values for this AP:
Setting
AP Name
SSID
Channel
IP Address
Subnet Mask
Gateway
Encryption
MAC Access Control
Password
Figure 1.8
Default Value
MiniAP
WLAN
1
192.168.2.50
255.255.255.0
192.168.2.1
Disabled
Disabled
default
18