JVC MX-K10/30 Service Manual page 9

Removing the front panel assembly
Prior to performing the following procedures, remove
the top cover a n d both side s board.
Also re move the CD changer unit.
1. Disconne ct the parallel wire a nd card wire from the
connectors CN702, CN701, CN101, CN850 on the
power a mp and supply PCB.
2. Remove the two screws "H" retaining the front pa
assembly onto the bottom of the body
3. Remove the screw "I" retaining the ca
mechanism a nd then re move then GND lug "b" that
comes from the power a mp and supply PCB.
4. Disengage the claws "c" on both side
of the front pa n el assembly a nd then re move the
assembly .
(See Fig.11 and 12)
nel
.
ssette de ck
s at the bottom
1-9