JVC MX-K10/30 Service Manual page 10

<Disassembly of units and assembly inside
this set>
Removing the CD PCB
Prior to performing the following procedures, remove
the top cover a n d both side s board.
Also re move the CD changer unit.
1. Disconne ct the wire s from CN603A, CN603B a nd
CN604 on the CD PCB, which is located on the ba
side of the CD changer unit.
2. The two screws "J" that retain the CD PCB should
be removed.
3. Remove the CD PCB by pulling it toward the side
where the CN601 is located.
4. Using solder, short the CD pickup to connect to short
round.
[Caution] After re-conne cting the wires, be sure to
remove the shorting solder from the
connection.
5. Disconnect the card wire from the conne
on the main PCB a n d then re move the main PCB.
1-10
(See Fig.13 and 14)
ck
GND
ctor CN601