JVC MX-K10/30 Service Manual page 14

Removing the switch PCB and sound
mode and CD function switch PCB
Prior to performing the following procedures, remove
the top cover and both sides board.
Also remove the CD changer unit.
Also remove the front panel assembly.
1. Pull out the volume control knob and MIC Volume
Knob from the front of the front panel assembly.
2. Remove the four screws "Q" retaining the front panel
assembly.
3. Remove the control / FL PCB.
4. Remove the eleven screws "R" retaining the switch
(key 1) PCB.
5. Remove the three screws "S" retaining the sound mode
(key 2) switch PCB.
6. Remove two screws "T" retaining the CD function (key
3) switch PCB.
1-14
(See Fig.24 to 27)