JVC LT-32WX84 Service Manual page 54

REMOVING THE LCD PANEL UNIT
The LCD PANEL is fixed to the FRONT PANEL (at the back
side) by using double-side adhesive tapes. To remove the
LCD PANEL UNIT, remove the adhesive tape on the FRONT
PANEL slowly.
CHANGING THE CONTROL PWB
CONFIRMATION PRIOR TO DISASSEMBLY
Before disassemble the LCD PANEL UNIT, confirm that
there is no damage in the LCD PANEL UNIT (polarizer).
1. DISASSEMBLY OF LCD PANEL
For removing the LCD PANEL UNIT, see page 1-13 "3.1.10
REMOVING THE LCD PANEL UNIT" in LT-32WX84/HA
service manual.
1.1 REMOVING THE CONTROL PWB
• Place the LCD PANEL with its backside facing upward. Be
careful not to damage the surface of the screen.
(1) Remove the 6 screws [A], and remove the CONTROL
PWB COVER.
(2) Remove the claws in the connectors, and pull out to
remove the FLEXIBLE WIRE.
NOTE:
Be careful not to damage the FLEXIBLE WIRE.
Especially during assembly procedure, be careful
not to insert the FLEXIBLE WIRE in the LCD PANEL
UNIT.
(3) Remove the CONTROL PWB.
1-2 (No.YA004B)
A
CONTROL PWB COVER
CONTROL PWB
Adhesive tape