JVC LT-32WX84 Service Manual page 21

(3) VIDEO STATUS
ST : STANDARD
DA : DYNAMIC
TH : THEATER
GA : GAME
(4) WHITE BALANCE
H : HIGH
L : LOW
(5) IP CHANGING MODE
FL : FRAME
L1 : LINE
23 : COMPULSORY NATURAL CINEMA IN
(6) MEMORY MODE
MUTE : Press [MUTING] key
DIR : Change data then memory at the same time.
4.5.6 SERVICE MODE SETTING
1. PICTURE/SOUND
AUDIO, VIDEO, DRIVE data adjustment.
(1) SETTING ITEM No.
A : AUDIO
S : SIGNAL
D : DRIVE
F : FACTORY SETTING
• Press [CH+] / [CH-] key
A01 S01
Item No. is up/down
• Press [SLEEP TIMER] key
A01 S01
Skip change
(2) SETTING ITEM NAME
Describe setting item name
(3) SETTING VALUE
Set the setting value.
• Press [VOL+] / [VOL-] key
Set the setting value.
• Press [MUTING] key
Memorize the data.
NOTE:
Setting for any of the following items that is not included in the
"ADJUSTMENT PROCEDURE" section found in the later part
of this manual will not be performed in servicing.
D01 F01
D01 F01
2. YC SEP (3D Y/C separation setting)
[Do not change settings of items that are not included in the
"ADJUSTMENT PROCEDURE" section. ]
Sets output data to the 3D Y/C separation circuit.
• Press [CH+] / [CH-] key
For scrolling up/down the item codes.
• Press [VOL+] / [VOL-] key
For scrolling up/down the data values.
3. WHITE BALANCE (White balance setting)
[Setting for this item is not required in servicing.]
4. MEMORY SETUP (Memory setting)
[Do not change settings]
5. RF AFC
Setting for this item is not required in servicing.
6. DD/CM
[Do not change settings]
Adjustment of color manegment and device driver
7. PANEL (Panel power limit control)
[Do not change settings]
8. PP (Multi-screen processing setting)
[Do not change settings of items that are not included in the
"ADJUSTMENT PROCEDURE" section.]
Sets output data to the multi-screen processing circuit.
• Press [CH+] / [CH-] key
For scrolling up/down the item codes.
• Press [VOL+] / [VOL-] key
For scrolling up/down the data values.
9. IP (DIST setting)
[Do not change settings]
Sets output data to the DIST circuit.
0. HDMI
[Do not change settings]
Sets output data to the DIGITAL INPUT circuit
(No.YA004)1-21