Toshiba RAV-SM2244DTP-E Installation Manual page 23

To recognize the position of the
corresponding indoor unit though the
indoor UNIT No. is known
Check the position during operation stop.
(Stop operation of the unit.)
1,3
1
Push + buttons simultaneously for
4 seconds or more.
After a while, the display part flashes and
the display appears as shown below.
In this time, the position can be checked
because fan of the indoor unit operate.
For the group control, the indoor UNIT No. is
displayed as [ ] and fans of all the indoor
units in the group control operate.
Check the displayed CODE No. is [01].
When the CODE No. is other than [01], push
button to clear the display and repeat procedure
from the first step.
(After pushing button, operation of the
remote controller is not accepted for approx.
1 minute.)
(* Display changes according to
the model No. of indoor unit.)
2
In the group control, every time
button is pushed, the indoor UNIT No. in
the group control is displayed in order.
In this time, the position of the indoor unit
can be confirmed because only fan of the
selected indoor unit operate.
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
43-EN
3
After confirmation, push
to the normal mode.
When button is pushed, the display
disappears and the status becomes the
normal stopped state.
(When button is pushed the operation from the
remote controller is not accepted for approx.
1 minute.)
1
2
8 °C Operation
button to return
Pre-heating operation can be set for cold regions
where room temperature drops to below zero.
1
Push +
for 4 seconds or more when the air
conditioner is not working.
After a while, the display part flashes as
shown below. Check the Displayed CODE
No. is [10].
When the CODE No. is other than [10], push
button to erase the display and repeat
procedure from the first step.
(After pushing
remote controller is not accepted for approx.
1 minute.)
(* Display changes according to
the model No. of indoor unit.)
2
Every time
indoor unit No. in the group control is
displayed in order. Select the indoor unit of
which setup is changed. In this time, the
position of the indoor unit of which setup is
changed can be confirmed because fan of
the selected indoor unit operate.
3
Specify CODE No. [d1] TEMP.
buttons.
4
Select SET DATA [0001] TIME
buttons.
SET DATA
0000
0001
5
Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
6
Push button.(Setup is determined.)
When button is pushed, the display
disappears and the status becomes the
usual stop status. (When
pushed the operation from the remote
controller is not accepted for approx.
1 minute.)
– 22 –
+ buttons simultaneously
button, operation of the
button is pushed, the
/
/
8 °C Operation setting
None
(Factory default)
8 °C Operation setting
button is
EN
EN
EN
EN
44-EN