Set Maclock Trap - Enterasys b5 Manual

Mode
Switch command, read‐write.
Usage
If there are more first arrival MACs than the allowed maximum static MACs, then only the latest
first arrival MACs will be moved to static entries. For example, if you set the maximum number of
static MACs to 2 with the set maclock static command, and then executed the set maclock move
command, even though there were five MACs in the first arrival table, only the two most recent
MAC entries would be moved to static entries.
Example
This example shows how to move all current first arrival MACs to static entries on ports
B5(rw)->set maclock move ge.3.1-40

set maclock trap

Use this command to enable or disable MAC lock trap messaging.
Syntax
set maclock trap port-string {enable | disable}
Parameters
port‐string
enable | disable
Defaults
None.
Mode
Switch command, read‐write.
Usage
When enabled, this feature authorizes the switch to send an SNMP trap message if an end station
is connected that exceeds the maximum values configured using the set maclock firstarrival and
set maclock static commands. Violating MAC addresses are dropped from the device's (or stack's)
filtering database.
Example
This example shows how to enable MAC lock trap messaging on
B5(su)->set maclock trap ge.2.3 enable
Specifies the port on which MAC lock trap messaging will be enabled or
disabled. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 7‐1.
Enables or disables MAC lock trap messaging.
set maclock trap
ge
.2.3:
ge
Enterasys B5 CLI Reference 22-67
.3.1‐40: