Clear Snmp Targetparams - Enterasys b5 Manual

noauthentication |
authentication |
privacy
volatile |
nonvolatile
Defaults
None.
If not specified, security level will be set to noauthentication.
If not specified, storage type will be set to nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to set SNMP target parameters named "v1ExampleParams" for a user
named "fred" using version 3 security model and message processing, and authentication:
B5(su)->set snmp targetparams v1ExampleParams user fred security-model usm
message-processing v3 authentication

clear snmp targetparams

Use this command to clear the SNMP target parameter configuration.
Syntax
clear snmp targetparams targetParams
Parameters
targetParams
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear SNMP target parameters named "v1ExampleParams":
B5(su)->clear snmp targetparams v1ExampleParams
(Optional) Specifies the SNMP security level applied to this target
parameter as no authentication, authentication (without privacy) or
privacy. Privacy specifies that messages sent on behalf of the user are
protected from disclosure.
(Optional) Specifies the storage type applied to this target parameter.
Specifies the name of the parameter in the SNMP target parameters table
to be cleared.
clear snmp targetparams
Enterasys B5 CLI Reference 8-25