Sony CDP-XE530 Service Manual page 9

QQ
3 7 63 1515 0
4-3. AGING MODE
This unit is equipped with an aging mode to check operations of the
mechanism deck.
• When faults occur:
Aging stops, and the state when aging stopped is displayed on the
fluorescent display tube.
• When no fault has occurred:
Aging is continued repeatedly.
Aging method 1
(When using the aging mode remote controller (J-2501-123-A)):
Press the U button and turn ON the power.
1.
2. Set the disc on the tray.
3. Press the AGING START button of the aging remote controller.
4. Aging starts and the message shown in Fig. 1 is displayed on
the fluorescent display tube.
To end, press the U button.
5.
Aging method 2 (When no aging mode remote controller):
Press the U button and turn ON the power.
1.
2. Set the disc on the tray.
Press the § OPEN/CLOSE button, p button, and MUSIC
3.
SCAN button at the same time. (If these buttons are not pressed
at the same time, nothing performs.)
4. Aging starts and the message shown in Fig. 1 is displayed on
the fluorescent display tube.
To end, press the U button.
5.
Fig. 1 Message in Aging Mode
TE
L 13942296513
Code
No.
0 Load in
1 Access to TOC
2
Access to last track
3 Playback of last track
(3 seconds)
4
Access to first track
5 Playback of first track
(3 seconds)
6
Load out
www
http://cxema.ru
http://www.xiaoyu163.com
Display when
State
normal
AGING-0
AGING-1
AGING-2
Counter display
AGING-4
Counter display
AGING-6
x ao
y
. i
http://www.xiaoyu163.com
8
[ MAIN BOARD ] – Component Side –
Q Q
3 6 7 1 3
Display when
abnormal
ERROR-0
ERROR-1
ERROR-2
ERROR-3
ERROR-4
ERROR-5
ERROR-6
u163
.
— 9 —
2 9 9 4 2 8
CN621
JW613 (ADJ)
JW617 (AFADJ)
1 5 0 5 8 2 9 9 4
m
co
9 9
2 8 9 9