Specifications; Fcc Notice - Radio Shack 2000649 / PRO-649 Owner's Manual

Specifications

Frequency Coverage
29-54 MHz .................................................................. (5 kHz steps)/FM
108-136.9875 MHz .............................................(12.5 kHz steps)/AM
137-144 MHz ........................................................ (12.5 kHz steps)/FM
144-148 MHz .............................................................. (5 kHz steps)/FM
148-150.8 MHz .................................................... (12.5 kHz steps)/FM
150.8-162 MHz .......................................................... (5 kHz steps)/FM
162-174 MHz ........................................................ (12.5 kHz steps)/FM
380-512 MHz ....................................................... (12.5 kHz steps)/FM
Sensitivity (S+N)/N 20 dB
29-54 MHz ...................................................................................... 0.5 uV
108-136.9875 MHz ........................................................................1.0 uV
137-174 MHz .................................................................................. 0.5 uV
380-512 MHz ..................................................................................0.7 uV
Spurious Rejection (FM @154 MHz) .........................................50 dB
Selectivity
±8 kHz/±17kHz (FM/AM) .................................................. -6dB/-50dB
Search Speed .......................................................Up to 80 Steps/Sec
Scan Speed ....................................................Up to 40 Channels/Sec
Delay Time.............................................................................. 2 Seconds
IF Frequencies
1st IF ........................................................................................... 10.7 MHz
2nd IF .............................................................................................455 kHz
IF Interference Ratio (10.7 MHz)..........................70 dB at 154 MHz
Squelch Sensitivity
Threshold (FM/AM) ...................................................Less than 0.5 uV
Tight (FM) ....................................................................... (S + N)/N 25 dB
Tight (AM) ........................................................................ (S+N)/N 20 dB
Antenna Impedance ...............................................................50 Ohms
Audio Output Power (10% THD) ..........................180mW Nominal
Built-In Speaker ................................. 1.37 Inches (36 mm), 8 Ohms
Operating Temperature .......................14° to 140°F (-10° to 60°C)
Power Requirements........................9V AC Adapter (not supplied)
................................................................ 9V DC Adapter (not supplied)
................................................................. 4 AA Batteries (not included)
Dimensions (HWD) ............................................. 5.68 x 2.37 x 1.56 In
.....................................................................................(145 x 63 x 40 mm)
Weight (without antenna) ............................................. 7.8 oz (220 g)
Specifications and depictions are subject to change and
improvement without notice. Actual product may vary from the
images found in this document.
30

FCC Notice

This equipment has been tested and found to comply
with the limits for a scanning receiver, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
31