Directions For Installation And Use; How To Install The Washing Machine - Daewoo DWF-4220 Series Service Manual

5. DIRECTIONS FOR INSTALLATION AND USE

HOW TO INSTALL THE WASHING MACHINE

Selection of the Installing Place
Install the washer on the horizontal solid floor.
If the washer is installed on an unsuitable floor, it could make
considerable noise and vibration.
How to install on an Inclined Place
1.
Height Setting
• After controlling the height by
turning the adjustable leg, let the
washer put down to the ground.
Installing the Drain Hose [Non-pump Model]
¡
In case that it goes over a
doorsill.
Don't let the height of the
drain hose exceed 20cm
from the gound.
2.
Check the Horizontal Status
• Check the position of tub above
the center of the washer.
™
In case of extending the drain
hose.
Don't let the total length
exceed 3m.
20Cm
Never install in these places.
• The place where it would be exposed to direct
sunlight.
• The place nearby a heater or heat appliances.
• The place where it would be supposed to be frozen in
winter.
• The kitchen with coal gas and a damp place like a
bathroom.
• The proper installation of the washing machine can
increase the wash effectiveness and the life of it.
If the washer is installed on an inclined floor, it could make considerable noise
and vibration and could cause a malfunction.
Use the height adjust rubber to adjust the washing machine so that it sits
properly.
£
Be careful that the end of the
drain hose is not immersed
in water.
3m
12
NOTES:
The opening must not be
obstructed by carpeting when
the washing machine is in-
stalled on a carpeted floor.